After install the WinTV-PVR 250/350/Freestyle board in a free PCI slot.


1: You should see Hardware Wizard.


2: Check the box "Specify the location of the driver" then click next button.


3: Check only Specify a location then click on the Browse button.


4: Click your CDrom or the folder where unpack base driver kit is at then click OK button.


5: Click Next

6: If all gose well you should this page then click next button.


7: It should copy some file


8: Now you should see this just click on the Finish button.


9: On CDRom or folder where unpack base driver kit is at you fine setup.exe run it select your Language.


10: Clik OK button


11: Check or Uncheck what you want.
Note: Don't uncheck MPEG SW Decoder you need them.
After it done install everything it very good idea to reboot (I recommended this).